Minebea Intec Maxxis 5 Phase PR 5900/81, Руководство по эксплуатации

Страница: 34 / 94

Analog output
Menu item Selection Description
[Data source] Weighing point
A…D
Output of the weight values from scales A or B.
0…Max are converted into 0/4 mA…20 mA.
[Analog value] Gross
Net/Gross
Net/0 mA
Net/4 mA
Net/20 mA
Output of the gross value
Output of the net value, if tared; otherwise gross
Output of the net value, if tared; otherwise 0 mA
Output of the net value, if tared; otherwise 4 mA
Output of the net value, if tared; otherwise 20 mA
[Range] 0…20 mA
4…20 mA
Output of 0…Max as 0…20 mA
Output of 0…Max as 4…20 mA
[On ADC error] 0 mA
4 mA
20 mA
hold
Set output to 0 mA.
Set output to 4 mA.
Set output to 20 mA.
The last output value is held.
[On < zero] 0 mA
4 mA
20 mA
hold
linear
Set output to 0 mA.
Set output to 4 mA.
Set output to 20 mA.
The last output value is held.
Only for [4…20 mA]:
Output goes below 4 mA until the limit is reached.
[On > Max] 0 mA
4 mA
20 mA
hold
linear
Set output to 0 mA.
Set output to 4 mA.
Set output to 20 mA.
The last output value is held.
Output goes below 20 mA until the limit is reached.
5.4.3.2 Adapting analog output
The analog output current on the receiving end (PLC) is generally fed through a resistor,
measured as a voltage and then digitized. The output current can be adjusted in small
ranges. This is required if small deviations from the nominal value occur in a connected
PLC.
Note:
Adapting the analog output, see PR 5900 operating instructions.
5.4.3.3 Digital outputs
1. Select and conirm [Option] using the cursor.
A selection window opens.
Phase PR 5900/81 5 Getting started
EN-32 Minebea Intec