Minebea Intec Combics CAPXS U Series, Руководство по эксплуатации, Страница: 7 / 24

6
Combics CAPXS.U
Combics CAPXS.U 7
Installation
7
Installation
§
Connect the cable of the weighing platform to a suitable indicator .
Note:
The cable gland along with the screw fasteners is already pre-assembled.
Use extreme care when attaching or detaching a cable.
§
Strip off the insulation at the cable end and attach the cable as follows:
– Route the cable through the cable gland.
– Properly tighten the screw fasteners of the cable gland
– Remove the sheathing from a section of the cable end (see illustration).
The shield (1) must have contact with the clamps (2).
– Expose approximately 15 cm (6 inches) of the wires (3) for installation.
§
Attach the cable to the weighing platform as follows:
– Expose approximately 5 cm (2 inches) of the wires for installation.
– Expose approximately 1 cm (1/2 inch) of the wires and attach ferrules to the wires.
– Securely attach the wires to the screw terminals
Wiring Diagram for the Indicator
No. Signal name Meaning Conductor coloring
1 BR_POS Bridge supply voltage (+) Blue
2 SENSE_POS Sense (+) Green
Bridge supply voltage
3 OUT_POS Measuring voltage (+) White
4 OUT_NEG Measuring voltage (-) Red
5 SENSE_NEG Sense (-) Gray
Bridge supply voltage
6 BR_NEG Bridge supply voltage (-) Black or brown
§ Use a screwdriver to tighten the terminal screws.
77
(+)