Mine Site Technologies NS50, Руководство пользователя, Страница: 94 / 126

Up to 8 VLANs can be defined. Each entry.x in the VLAN section represents a VLAN. By default, the
site configuration file has some VLANs predefined based on commonly used applications. VLAN
parameters are described in the table below.
Description Field
Sets whether VLANs are enabled on the switch. vlan.enabled
Enables VLAN x. Typing 1 will enable the VLAN, 0 will disable
the VLAN. vlan.entry.x.enabled
The VLAN ID that will be tagged to frames sent to trunk ports from
VLAN x. vlan.entry.x.id
Priority from 0-7 (with 7 being the highest) that is assigned to frames
on VLAN x. vlan.entry.x.priority
The administrative name for VLAN x. vlan.entry.x.name
Note: The Infrastructure VLAN cannot be edited or disabled because the management CPU is on
this VLAN.
For more information on VLANs, refer to Understanding VLANs on page 45.
6.3.8 Wireless EAP Configuration
The Wireless EAP section is used to configure the RADIUS server as shown below. This is applicable
for wireless networks configured with WPA Enterprise security mode.
Wireless EAP Configuration
==========================
wireless.eap.reauth_time=120 # 1 - 65535
wireless.eap.primary.auth_mac=1
wireless.eap.primary.server_address=192.168.1.220
wireless.eap.primary.server_port=1815
wireless.eap.primary.shared_secret='secret1'
wireless.eap.secondary.auth_mac=0
wireless.eap.secondary.server_address=192.168.1.221
wireless.eap.secondary.server_port=1816
wireless.eap.secondary.shared_secret='secret2'
A primary and secondary (backup) RADIUS server can be set up and configured. A description of the
editable parameters are shown in the following table.
Settings Description Field
Setting is at 120 minutes by default. Amount of time in minutes before a client
device is required to re-authenticate. reauth_time
Authentication is enabled by typing
1 or disabled by typing 0. Access to the RADIUS server by confirmation
of the MAC address of the client device. auth_mac
n/a. The IP address of the authentication server. server_address
By default the port number is 1812. The port number used to connect to the
authentication server. server_port
Password that matches with the
authentication server. Password used by the Access point to access
the RADIUS server. shared_secret
Revision A 94 NS50 User Manual
Centralised Configuration Management