If you have any questions, please call MINCEY MARBLE CUSTOMER SERVICE at 1-800-533-1806.
Mincey Marble Mfg., Inc.
|
4321 Browns Bridge Road, Gainesville, GA
|
800.533.1806
|
www.minceymarble.com
AREZZO BYPASS BARN DOOR ENCLOSURE SYSTEM INSTALLATION
3
These instructions are to be followed assuming the Shower Pan is level and the Walls are plumb. After you have
FRQ¿UPHGWKDWDOORIWKHUHPDLQLQJSDUWVDQGSLHFHVDUHSUHVHQW\RXDUHUHDG\WREHJLQE\SUHSDULQJWRLQVWDOO
WKH:$7(5*8$5'¿UVW
Start by measuring the distance between the Wall Panels just above the Shower Pan Curb, and deducting
3
/16”
tolerance for the Vertical Wall Channels. Trim the WATER GUARD using the Portable Band Saw or Hack Saw.
The WATER GUARD can be trimmed from either end. Then, slide the CENTER DOOR GUIDE onto the WATER
GUARD. You will center and install the Door Guide later.
MEASURE WALL TO WALL
AT THE PAN CURB,
TRIM WATER GUARD
DEDUCTING 3/16” FOR
VERTICAL WALL CHANNEL
TOLERANCES
SLIDE THE CENTER DOOR
GUIDE INTO THE WATER
GUARD USING THE TAB ON
THE END OF THE GUIDE
CENTER LOOSELY ON WATER
GUARD, WILL INSTALL
PERMANENTLY LATER
Next, Mark and Drill the holes for the LEFT VERTICAL WALL CHANNEL making sure it is Plumb with the Level.
Also, be sure to center the VERTICAL WALL CHANNEL on the Shower Pan Curb. Clean up any debris or
shavings. Install the WALL ANCHORS in the Wall Panels in the three Top, Center and Bottom locations.
Place the WATER GUARD with CENTER DOOR GUIDE on the Top of the Curb. Install the LEFT VERTICAL WALL
CHANNEL while sliding the WATER GUARD into the slot manufactured from the factory in the Front of the
VERTICAL WALL CHANNEL.
PLUMB LEFT VERTICAL
WALL CHANNEL WITH
LEVEL, MARK LARGER HOLE
LOCATIONS AND REMOVE
SCREW
TO WALL
HOLES
HAMMER
IN ALL
THREE
ANCHORS
SCREW
IN WALL
CHANNEL
REMOVE WALL
CHANNEL, DRILL HOLES
WITH 5/16” MASONRY
BIT, HAMMER IN
WALL ANCHORS
CLEAN DEBRIS AND
SHAVINGS, PLACE WALL
CHANNEL AND SCREW
INTO PLACE
1 1/4”
PAN HEAD
SCREWS
WALL
ANCHORS
PAN
BUMPER
HOLES
SLIDE THE WATER GUARD WITH
THE CENTER DOOR GUIDE INTO
THE FACTORY SLOT IN THE FRONT
OF THE VERTICAL WALL CHANNEL
THEN INSTALL THE VERTICAL
WALL CHANNEL
