17
Operation
Decelerating to minimum speed or coasting to a stop is
recommended for frequent stops. Do not use any of these methods
for emergency stopping. They may not stop a drive that is
malfunctioning. Removing AC line power (both L1 and L2) is the
only acceptable method for emergency stopping.
For this reason, Minarik strongly recommends installing an
emergency stop switch on both the L1 and L2 inputs (see
Connections, page 9).
Warning
m
3. Slowly advance the speed adjust potentiometer clockwise (CW). If the drive is
following a voltage signal, slowly increase the voltage signal. The motor slowly
accelerates as the potentiometer is turned CW, or the voltage signal is increased.
Continue until the desired speed is reached.
4. Remove AC line voltage from the drive to coast the motor to a stop.
If the motor or drive does not perform as described, disconnect the AC line voltage
immediately. Refer to the Troubleshooting section, page 38, for further assistance.
Starting and Stopping Methods
