ENG
14
3. Cutting of pole
Instructions for cutting the mast to adapt the support length to
the height of the ceiling:
1. Remove the 3 screws (1).
2. Take the pole out, separating it from part (2) .
3. Cut the pole to the desired measurement.
4. Make the three holes of the same measurement in the pole (3).
5. Assemble and insert screws.
4. Attachment and anchorage
1. Position the support on the ceiling.
2. Mark the 5 support holes to install the attachment.
5. Electrical connection
1. Insert the cable into the bottom of the pole.
(Cable protection according to regulations)
2. Connect the cable to the power network using standardized
protected connectors.
3. Conceal the connectors inside the pole or in the upper part.
The attachment calculations shall be the
responsibility of the Structures Technician.
Ø 250mm
Ø 230mm
Ø 5 X 8,5mm
