MIMAKI TS34-1800A, Руководство по обслуживанию

Страница: 96 / 262

© 2011 MIMAKI ENGINEERING CO.,LTD. 4.2.10 P.1
1
2
3
4
5
6
7
8
MAINTENANCE MANUAL > Adjustment Items > Adjustment Function > HEAD ID
Model TS34-1800A Issued 2011.10.17 Revised F/W ver. 1.20 Remark
1.0
Rev.
R.1.0
4.2.10 HEAD ID
 Function
Head ID input is normally executed by the machine automatically.
The head memory PCB assy is mounted on the head unit assy, and the ID information is written in the mini memory
PCB assy.
 Procedure (In case of manual input)
1. Prepare a head ID.
2. Select [HEAD ID] from the operation menu.
3. Select the head to which you enter the head ID.
4. Enter the head ID.
[ENTER]: Determines and saves.
Head ID is for compensating differences of discharge amount of ink among each head. A label on which a
compensation value (ID: in 24 digits) is written is attached on a head at the factory shipment.
This head ID is stored in the machine using the parameters so that print quality is consistent.
Manual input of the ID information is required in the following cases.
 In a case that the ID information is not stored in the mini memory PCB assy:
[HEAD ID Un input] is displayed on the panel (at power on)
 Pay attention when replacing PCB, because even if the head ID is not identical to the ID information in
the memory PCB assy (a PCB of another head is placed, for example), the error is not displayed on the
panel.
Manual input of ID is recommended if there is a doubt on the agreement between the ID of a head and
the ID information in the memory PCB assy.
Head ID (38 digits)
< L O C A L . 1 > [#01]
F U N C T I ON
# A D J U S T
<ENT>
# A D J U S T
H E A D I D
<ent>
# A D J U S T
S E L E C T
:HEAD-1
# H EA D I D / 1 1
* ** * * * * * ********
If the ID, which has been input, is incorrect, operation
error (ERROR 30) is displayed.