5
Caution for Use
Caution
Handling of MBIS3
• Even when not using MBIS3, keep the 2L ink pack be set. If the
2L ink pack is not set, the male connector end located in the
center of the seat will be solidified and supplying ink to the
printer will not be available or ink leakage may occur.
If the ink becomes clogged, use a cotton swab dabbed in the
dedicated cleaning solution to remove the solidified ink.
• Do not set the 2L eco case without 2L ink pack on the jack
stand. Doing so will result in air from the male connector being
mixed in causing an ink discharge fault.
Using dedicated ink
• Be sure to use dedicated ink for the printer to be connected. It will not operate with ink other than the
dedicated one because of protecting the printer.
How to Handle Ink Packs
• If the ink pack is moved from a cold place to a warm place, leave it in the room temperature for three
hours or more before using it.
• Open the ink pack just before installing it in the machine. If it is opened and left for an extended period of
time, normal printing performance of the machine may not be ensured.
• Make sure to store ink packs in a cool and dark place.
• Be sure to thoroughly consume the ink in the ink pack, once it is opened, within three months. If an
extended period
of time has passed away after opening the pack, printing quality would be poor.
• When you removed the 2L ink pack from the seat before it
ends, wipe ink adhering to inside of the connector part of the
2L ink pack with a cotton swab etc.
If ink adhering to inside of the connector part may dry out, it
may cause ink leakage when using it again.
•
To change the ink type or the color after installing MBIS3, replace the ink tube
, spout rubber
and the
seat.
Contact with sales office or our business office.
• Never refill the ink pack with ink. Refilled ink pack can cause a trouble. Remember that MIMAKI assumes
no responsibility for any damage caused by the use of the ink pack replenished with ink.
• Neither pound the ink pack nor shake it violently, as doing so can cause leakage of ink.
Do not leave the ink slot empty
• Do not leave the ink slot empty for a long time. Leaving it empty may dry the slot and solidify the ink in the
machine, then the machine will become unable to supply ink.
• If ink cartridges are not set in the ink slot, an error message will display on the printer to set ink cartridges.
Set the same colored ink cartridge as the ink used before.
Tube breakage
• Be careful that the exposed tube does not break in the following conditions.
s
Contact with sales office or our business office.
1. When moving the tube to the rear of the printer for setting media or other reasons.
2. When removing and pulling out the middle cartridge.
3. When replacing the 2L ink pack.
