MIMAKI CF-0907, Инструкция по эксплуатации

Страница: 23 / 170

— 1.7 —
Right-hand side face of the electrical box
Blower unit
Name Function
1 Power switch Used to turn on/off the power to the blower unit. Normally, it is set to the
on position. Turn it off when conducting maintenance works.
2 Signal wire connector To be connected, using a signal wire, to the signal wire connector for the
blower on the electrical box.
3 Power connector The power cable for the blower is connected to this connector.
Name Function
1 Power connector To be connected to the power cable of the plotter.
2 Main power switch Used to turn on/off the main power of this device. Normally set it to the on
state. Set it to the off state when conducting maintenance works.
3 Foot switch connector Foot switch for vacuum is connected to this connector. (Optional)
Note: The shape of this connector may differ from that shown in the photograph.
4 RS-232C interface To be connected to a personal computer using an interface cable.
5 IC card slot To be used when conducting maintenance works.
6 Signal wire connector for To be connected to the blower unit using a signal wire.
blower
7 Optional connector An optional device is connected to this connector.
1 2 3 4 5 6 7
1 2 3
• When using a separately sold
blower that differs from the stan-
dard blower, there may be no
power switch. For the output
voltage, refer to the value display
on the blower unit.