3
4.
Lift until the Battery Bay lifts off the floor and the
legs lock into place.
5. To collapse, press the Leg Release Button and slide
in the legs using the Carrying Handle. Keep hands
clear of the legs as they collapse.
Extending/Collapsing the Extension Poles
Extend or collapse the two poles to set the light at the
desired height.
1. Extend and lock the legs.
2. Open the top extension latch and raise the head out
of the housing. Extend the pole to the desired height.
3. Fully close top extension latch.
4.
If more height is needed, fully extend first pole and
close latch before opening bottom latch.
5. Continue to raise the head to the desired height.
6. Fully close bottom extension latch.
7. Rotate the head to the desired angle.
OPERATION
Use the switch to cycle through High, Medium, Low,
and OFF. Press and hold to turn OFF from any setting.
MAINTENANCE
WARNING
To reduce the risk of
personal injury and damage, never immerse your
tool, battery pack or charger in liquid or allow a
liquid to flow inside them.
Cleaning
Keep tool handles clean, dry and free of oil or grease.
Use only mild soap and a damp cloth to clean the tool,
battery pack and charger since certain cleaning agents
and solvents are harmful to plastics and other insulated
parts. Some of these include gasoline, turpentine,
lacquer thinner, paint thinner, chlorinated cleaning
solvents, ammonia and household detergents contain-
ing ammonia. Never use flammable or combustible
solvents around tools.
ACCESSORIES
WARNING
Always remove bat
-
tery pack before changing or removing acces
-
sories. Only use accessories specifically recom
-
mended for this tool. Others may be hazardous.
WARNING
To reduce the risk
of injury, always unplug the charger and remove
the battery pack from the charger or tool before
performing any maintenance. Never disassemble
the tool, battery pack or charger. Contact a
MILWAUKEE
®
service facility for ALL repairs.
Maintaining Light
Tightening
If the head or extensions will not hold their position, the
screws may need to be tightened. Tighten the bracket
screws holding the head, Tighten the extension latches
by open the latches and tighten the screw inside.
Keep your light, battery pack and charger in good
repair by adopting a regular maintenance program. If
the light does not work properly, return the light to the
store where the product was originally purchased or
one of our authorised
MILWAUKEE
®
service centres.
For a complete listing of accessories refer to your
MILWAUKEE
®
accessories catalogue or go online to
www.milwaukeetools.com.au or
www.milwaukeetools.co.nz. To obtain a catalogue,
contact the store where the product was originally
purchased or one of our authorised
MILWAUKEE
®
service centres.
Tightening
To increase the holding
Hand-tighten
Screws
force of the poles, tight-
en the extension latch-
es. Open the latches
and hand-tighten the
screw inside. Do not
over tighten, it will dam-
age the latches. Never
use power tools.
