For best result use only this portion of disc
Hold at a
5° to 15° angle
8
General Operation
1.
2. Use a clamp, vice or other practical means to hold
the workpiece, freeing both hands to control the
tool.
Paddle Switch Operation
To
start
the tool, grasp the handle and side handle
the paddle switch.
To
stop
the tool, release the paddle switch. Make
sure the tool comes to a complete stop before laying
down the tool.
Using Grinding Wheels
WARNING
The guard type must match the
3.
NOTE:
If the battery is inserted when the tool is
ON, the tool will not run. Turn the tool OFF, then
back ON to begin work.
4. Allow accessory to come to full speed before
beginning work.
5. Control pressure and surface contact between ac
-
cessory and workpiece.
comes to a complete stop before laying it down.
wheel type to provide maximum
protection for the operator if the wheel should
break.
When grinding, hold tool at a to
angle, using
angle causes concentrated pressure on small areas
which may gouge or burn work surface.
-
low notching operations only.
WARNING
The guard type must match the
wheel type to provide maximum
protection for the operator if the wheel should
break.
WARNING
Using Wire Brushes
Wire brushes are useful for removing rust, scale,
burrs, weld slag, etc.
Never exceed Maximum Safe Operating Speed of
brush. Do not use a damaged brush or one that
is functioning improperly (throwing wires, out-
of-balance, etc.). These conditions increase the
possibility of further brush failure and possible
injury. Discard and replace damaged brushes
immediately.
If you have just installed an accessory or are
beginning a period of work, test the wheel by
letting it spin for one minute before applying it to
the workpiece.
WARNING
Never use a accessory that has
been dropped. Out-of-balance or
damaged accessories can mar workpiece,
damage the tool, and cause stress that may
cause accessory failure.
WARNING
Hold tool securely with both
hands. Start the tool.
WARNING
Never bang accessory onto
work.Too much pressure causes
accessory failure or slows speed.
WARNING
When using a cut-off wheel, hold the tool as shown,
using only the edge of the wheel.
Using the face of a Cut-Off Wheel
(as in grinding) will cause the Wheel
to crack and break, resulting in serious personal
injury.
Everyone in the area must wear
protective clothing and safety
goggles or face shields marked to comply with
AS/NZS 1337.1. Fatigued wires and residue will
fly off the brush with considerable force,
causing potential for serious injury.
OPERATION
WARNING
To reduce the risk
wear proper eye protection marked
of injury, always
to comply with AS/NZS 1337.1.
Never grind without proper safety equipment.
Speed dial
(M18 FAGV125XPDB)
Controlled Start
The controlled start feature reduces the torque reac
tion "jerk" when the trigger is pulled.
Electric Brake
WARNING
both
Always
hand
hold
s u
the
sing
tool
the hand
with
les
provided before and during grinding.
When working in dusty situations, wear
appropriate respiratory protection or use a
suitable dust extraction solution.
MILWAUKEE
®
Variable Speed Angle Grinders have
a speed dial located on the end of the handle to set
the maximum speed. Rotate the speed dial to “5” for
maximum speed, “1” for minimum speed.
The electric brake engages when the switch is
released, causing the wheel to stop within seconds.
There may be a delay between the time the switch is
released and when the brake engages.
Occasionally the brake may miss completely. If the
brake misses frequently, have the tool serviced by
an authorised
MILWAUKEE
®
service facility. Make
sure the tool comes to a complete stop before laying
it down.
Содержание M18 FAG125XPDB
Страница 11: ......
