Milwaukee M18 FAG125XPDB, Руководство оператора

Страница: 6 / 12

6
7. To adjust the guard, press in the guard lock lever
Operator's Zones
1.
2.
Installing/Removing the Type 1
Clip-on Guard
When using a Type 1 wheel, always use the Type 1
clip-on guard.
clip-on guard over the Type 27 guard until it clips
into place.
3. To install the Type 1 clip-on guard, slide the Type 1
Remove the battery pack.
Properly install the Type 27 guard according to the
instructions, and adjust it properly to provide the
operator with maximum protection while operating.
4. To remove , remove the battery pack and then
separate the Type 1 clip-on guard from the Type
27 guard.
WARNING
To reduce
use a side handle
the risk of
when
injury,
using
always
this
tool. Hold securely.
WARNING
Only use accessories with Maxi-
‡
wetness and extreme humidity
‡
any type of solvent
‡
extreme changes in temperature
‡
dropping and bumping
‡
in an organised way so wheels can be removed
without disturbing or damaging other wheels
‡
with their safety information
rolled or bumped.
Discard wheels that have been dropped, rolled,
bumped, subjected to extreme changes in tempera-
ture, or come into contact with solvents or wetness.
mum Safe Operating Speed rated
at least equal to the maximum speed marked on
the power tool. This speed is based on the
strength of the wheel, allowing for a reasonable
measure of safety. It is not meant to imply a best
the Maximum Safe Operating Speed.
WARNING
Always adjust the guard to
provide the operator with
maximum protection while operating.
Installing Side Handle
The side handle may be installed on either side of
the gear case. Position the side handle in the loca-
To install, thread side handle into side handle socket
and tighten securely.
WARNING
T
operator should
o reduce the risk of injury
be instructed
, the
in
the use, care and protection of grinding wheels.
Grinding Wheel Selection
Use grinding wheels, and accessories that are:
‡
correct size as written on tool’s nameplate.
‡
rated at or above the RPM listed on the tool’s name-
plate.
‡
correct accessory, wheel type and grit for the job.
Grinding is the cutting action of thousands of
abrasive grains on the face of a grinding wheel.
When grinding metals such as steel and iron,
choose an aluminium oxide grinding wheel. Select
a silicon carbide grinding wheel for stone and
concrete. Use cotton reinforced wheels for
non-ferrous metals.
Type 1 reinforced 3.0 mm (1/8") thick or less Cut-Off
Wheels are suited for small cut-off and shallow
notching operations only. Always handle wheels
carefully to avoid damage. Before installing any
wheel, always inspect it for cracks. If wheel is
cracked, discard it to prevent others from using it.
1. To remove the guard, remove the battery pack
and remove any accessories from spindle.
2. Press in the guard lock lever and rotate the guard
to line up the tabs on the grinder with the slots in
the guard.
3. Press in the lock lever and lift the guard straight
up and away from the tool.
Removing/Installing/Adjusting
the Type 27 Guard
This tool is shipped with a guard. Always use a guard
unless otherwise indicated by these instructions.
y r e tt a b e h t . 4 guard,
from
pack remove and
5.
spindle. the
with the slots in
accessories
tabs on the grinder
guard lock lever and press the guard
onto the tool.
6. Press in the
To install the
remove any
NOTE: Use
with 125 mm
Line up the
the guard.
(5") grinding wheels only 125 mm
(5") guards.