16
English
16
6. Release the trigger. The LCD displays the torque reading
for 5 seconds.
Adjusting the torque range
The torque range indicates the acceptable range of values
for a successful install. Adjust the torque range to meet the
recommended torque speci
fi
cations.
Adjusting the rundown torque
The rundown torque is the approximate torque value when
the motor stops driving the product. The product tightens the
fastener to the selected preset percentage and then stops.
Manually tighten to reach the target torque.
NOTE:
The rundown torque changes the product's output
power. Adjust the rundown torque to prevent over-adjusting
the torquing target of the torque fastener.
Adjusting the target torque
The target torque is the required torque value for the fastener
being installed. Adjust the target torque to meet the required
torque speci
fi
cations.
DISPLAY ALERTS
Memory Almost Full
Memory Full
Dismiss
Dismiss
Memory for Saved Events
The product has a limited
amount of memory dedicated to
saved events.
NOTE:
The display prompts
that the memory is close to
being full or reached capacity.
Battery Over Temperature
Dismiss
Over Temperature
If the product overheats, a
warning is displayed. Turn o
ff
the product and allow it to cool
down before continuing.
TROUBLESHOOTING
Problem
Cause
Solution
The product does
not turn on when
the power button
is pressed.
The battery is
not installed or
charged.
Insert, replace,
or charge the
battery.
Firmware issue
Turn o
ff
the
product, and
remove the
battery.
Return the
product to a
service centre for
calibration.
Torque reading
is out of
speci
fi
cation.
Calibration is
required.
Return the
product to a
service centre for
calibration.
The product's
settings were
not saved when
the battery was
removed.
The battery was
removed before
the setting was
saved.
Re-enter the
settings, and
press and hold
the power button
to power down
the product
before removing
the battery.
Torque zero error
Torque was
applied while
zeroing.
Remove the
torque and re-
zero the product.
The product is
over-torqued.
Return the
product to a
service centre for
calibration.
The product was
not calibrated
correctly.
Return the
product to a
service centre for
calibration.
Failure of the
torque sensor
Return the
product to a
service centre.
Overtorque
125% of the
maximum torque
rating has been
applied to the
product.
Return the
product to a
service centre for
calibration.
Torque overload
150% of the
maximum torque
rating has been
applied to the
product.
Return the
product to a
service centre for
calibration.
Display prompts
"Memory Error".
Memory failure
Clear the data in
memory.
Display prompts
"Torque
Uncalibrated".
The torque is
uncalibrated.
Return the
product to a
service centre for
calibration.
Display prompts
"Warning".
The product
needs attention.
Follow the steps
from "Warning" to
"Proceed".
Display prompts
"Battery Over
Temperature".
The product has
exceeded the
peak temperature
while running.
Turn o
ff
the
product, and
remove the
battery pack.
Display prompts
"Certi
fi
cation
Needed Soon".
The product will
soon exceed the
expiration date for
certi
fi
cation.
Return the
product to a
service centre for
calibration.
Содержание M12 ONEFTR12
