6
2. Turn the tool to
Vertical Leveling Accuracy
1.
ON. Turn on one Vertical Plane.
3. Position the tool with the laser line towards the
door opening. Allow the tool to self-level.
4.
2.5m
2.5m
2.05m
5. Move the laser level directly behind point II on
6.
7.
the other side of the door. Align the same vertical
laser line so the centre is directly aligned with
points I and II.
8.
Mark the centre of the vertical line at the upper
edge of the door opening (point IV).
Measure the height of the door opening.
The distance between points III and IV on the
upper door opening is the vertical deviation (d)
of the tool.
d
9.
10. Repeat process with other Vertical Plane.
WARNING
To reduce the risk of personal in-
MAINTENANCE
WARNING
To
remove
reduce
the
the
battery
risk of
before
injury,
perform
always
-
ing any maintenance. Never disassemble the tool.
Maintain Laser Level
Maintain tools. If damaged, have the tool repaired
before use. Accidents may be caused by poorly
maintained tools.
jury and damage, never immerse
them.
Cleaning
Cleaning the Lenses
Carefully wipe the surface with a cotton swab moist-
ened with water.
Repairs
ACCESSORIES
WARNING
Use
designated accessories.
tools only with specifically
Use of any
other accessories may create risk of injury.
A door opening with approximately 2.5m of space
on each side of the opening is required for this
check.
Securely mount the tool 2.5m from one side of
the door opening.
Mark the centre of the vertical laser line on the
floor in the middle of the door opening (point I),
at a distance of 2.5m beyond the door opening
(point II), and at the upper edge of the door
opening (point III).
Keep tool handles clean, dry and free of oil or
grease. Use only mild soap and a damp cloth to
clean the tool since certain cleaning agents and
solvents are harmful to plastics and other insulated
parts. Some of these include gasoline, turpentine,
lacquer thinner, paint thinner, chlorinated cleaning
solvents, ammonia and household detergents
containing ammonia. Never use flammable or
combustible solvents around tools.
The maximum vertical deviation (d) is:
d max = 2XH (door opening) x ±3.18mm ÷ 10m
Example: for a door opening height of 2.13m,
the maximum permitted deviation (d) is:
d max = 2 x 2.05m x ±3.18mm ÷ 10m = ±1.3mm
Therefore, the measurement between points III
and IV on the upper door opening should not
exceed 1.3mm in a 2.05m doorway.
This tool has limited serviceable parts. Do not open
housing or disassemble tool. For repairs, return the
tool, battery pack and charger to the nearest
authorised service centre.
Содержание M12 3PLA
Страница 7: ......
