Milnor Mark II, Операция

Страница: 17 / 92

š
š!ššqšªª
The limits on the standard unload sequence parameters were exceeded
during the last discharge.
RECOVERY: Press
to resume operation. If the message returns, request management
assistance to set the parameters within the limits.
šš
One of six errors occurred.
RECOVERY: Press
to resume operation. If the message returns, recover as follows:
Adjust the gas pressure to within Milnor specifications. Press
/
and to
resume operation.
Adjust the gas pressure to within Milnor specifications. Press
/
and to
resume operation.
N
Request authorized service. Press
/
and to resume operation.
M
Adjust the gas pressure to within Milnor specifications. Press
/
and to
resume operation.
Press the flame control unit reset button and
/
. Press to resume
operation. If the error persists, request authorized service.
Adjust the gas pressure to within Milnor specifications. Press
/
and to
resume operation.
9^dUbbe`dY_^cBUaeYbY^W=Q^QWU]U^d1ccYcdQ^SU
—These errors usually require accessing program data and procedures found in the reference manual.
šš!
š!šš
Configure data or program data was corrupted.
RECOVERY: Request management assistance to clear the memory, then reprogram and
reconfigure the machine and gains.Return to run mode to resume operation.
o#jHšš
šš
A circuit board is failed or is missing.
RECOVERY: Press . Request management assistance to verify that configure values match
the equipment and options. If the message returns, request authorized service.
š
An invalid password was entered during manual intervention.
RECOVERY: Enter a valid password.
šš
The work order number is not in Mildata memory.
RECOVERY: Enter a valid number.
3_bbUSdY^W5bb_bc±4biUb =C?E4EDC15)$#&1F"#
13