Milnor 60 Series, Руководство по обслуживанию

Страница: 27 / 89

Chapter 3. Routine Maintenance
PELLERIN MILNOR CORPORATION
Table 3: Filters, Screens, and Sensitive Components
Remove contamination from these components to prevent damage and unsatisfactory performance.
Mark
1
2 3 4 5 6
Do this each Component
More Data. See also Section 3.1.3 “How
to Remove Contamination”
x
40 to 60 hours
inverter fans, vents, filters See Figure 8 . Keep good air flow.
x 600 hours
motors Keep good air flow.
x 2400 hours
entire machine Remove excessive dust and dirt.
x
day*
chemical inlet areas Some chemical supplies that stay on machine
surfaces will cause corrosion damage. See
Figure 9 and Section 2.2. “Prevent Damage
From Chemical Supplies and Chemical
Systems”
x 2400 hours
strainer in water regulator for
optional supply injector and
pumped chemicals on some
models.
See Figure 10
x 200 hours
strainer(s) for air inlet See Figure 13
x 200 hours
strainer for steam inlet.
(Steam is optional on some
models.)
See Figure 12
x 2400 hours
proximity switches See Figure 15
x
40 to 60 hours
breather for bearing
housing—front and rear
See Figure 16
x 200 hours
grease relief ports—front and
rear
See Figure 16
Table 4: Fluid Containers
Examine. Add fluid if necessary and keep components clean to prevent damage.
Mark
1
2 3 4 5 6
Do this each Component
More Data. See also Section 3.1.4
“Lubricant Identification and Procedures”
x 600 hours
See Supplement 5 and Figure 20 . Examine
the oil quality. Remove the used oil if
contaminated. Add the oil given below to
the height of the fill port.
x 2400 hours Hydrocushion
™
cylinders
Remove the used oil. Add oil to the height of
the fill port. Add the type of oil that applies to
your machine type ( Table 10 ).
42044_, 60044_, 72044_ = oil 1030
M7_ centrifugal extractor = oil 220
M9_ centrifugal extractor = oil 32
x 200 hours
Disk brake reservoir See Figure 21 . Examine the oil level and
quality. Add oil Dot3 ( Table 10 ) if necessary.
If the oil is contaminated, it is necessary to
bleed the brake system. Speak to your dealer
or Milnor. This is not routine maintenance.
23