Milnor 30015V8Z, Руководство по установке

Страница: 18 / 59

16
Pellerin Milnor Corporation
meters). Use the next larger size for runs 50 to 100 feet (15 to 30 meters). Use wire two sizes larg-
er for runs greater than 100 feet (30 meters). If an inverse time circuit breaker is used and local
codes require a larger wire size than that specified by Milnor, abide by the local code.
NOTICE:
The specified wire size may appear too small for the fuse or circuit breaker
shown. However, it is consistent with both the load imposed and with the USA National
Electric Code.
Ground
BNUUUF01.R03 0000109239 D.2 C.4 A.4 1/2/20 2:14 PM Released
The ground wire and connections must ensure a reliable earth ground (zero potential). Use wiring
of at least as large a gauge as that required for incoming power. Do not rely on conduit, machine
anchorage, etc. Use the ground lug provided in the incoming power junction box on the machine.
Disconnect Switch for Lockout/Tagout
BNUUUF01.R04 0000109238 D.2 C.4 A.5 1/2/20 2:14 PM Released
The disconnect switch must permit personnel to disconnect and lockout/tagout electric power
from the machine. In the USA, refer to OSHA standard 1910.147 “The control of hazardous en-
ergy (lockout/tagout)”. Refer to the USA National Electric Code for requirements on locating the
switch. In other locales, abide by these standards if no other local codes apply.
BNUUUI01 / 2019392
BNUUUI01 0000189337 C.3 1/2/20 2:14 PM Released
Vital Information About the Forces Imparted to Sup-
porting Structures by Laundering Machines
BNUUUI01.C01 0000189336 D.2 C.3 A.5 1/2/20 2:14 PM Released
This document replaces Milnor ® document BIWUUI02.
All laundering machines impart static and dynamic forces to the supporting structures (foundation
and soil, floor, and building). Static forces include the machine weight plus the weight of the
goods and water. Dynamic forces are those imparted by various machine movements as explained
in
: Major Design Considerations, page 17 . The dynamic forces imparted to supporting structures
can cause vibration and noise outside of the laundry room if supporting structures are inadequate.
Disclaimer of Responsibility
BNUUUI01.C02 0000189359 D.2 C.3 B.3 1/2/20 2:14 PM Released
Pellerin Milnor Corporation accepts no responsibility for damage or loss as a result of:
• inadequate supporting structures
• interference with the use of the facility caused by machine operation
The facility owner/operator is solely responsible to ensure that:
• supporting structures are strong enough, with a reasonable safety factor, to safely support the
operating machine or group of machines
• supporting structures are rigid enough to isolate vibrations and noise to the laundry room
Important Installation Precautions