Table of Contents
PELLERIN MILNOR CORPORATION
Sections
Figures, Tables, and Supplements
1.2.
About the Forces Transmitted by Milnor
®
Washer-
extractors
(Document BIWUUI02)
1.2.1.
Foundation Considerations
1.2.2.
How Strong and Rigid?
Figure 4: How Rotating Forces Act on the
Foundation
1.3.
Important Instructions for Pumped Chemical Inlets
(Document BIWUUI01)
1.3.1.
How Pumped Chemical Systems can Internally Damage
the Washer-extractor
Supplement 1: Preventing Dribbling by
Purging Chemical Lines
1.3.2.
Locating Chemical System Components to Reduce the
Risk of Internal Damage
Figure 5: Proper Routing of Chemical
Tubing
1.3.3.
Preventing Leaks Which Can Injure Personnel and Cause
External Damage
Figure 6: Rear-mounted Water and Liquid
Supply Injector
Figure 7: Rear-mounted Water Inlet
Assembly (C_E Models)
1.4.
Electrical Connections for Liquid Chemical Systems
(Document BICEUI01)
1.4.1.
Pump Signal Connections
Table 2: Chemical Injection Signals
Figure 8: Pump Signal Connections
1.4.2.
Timer Stop
Connections
Chapter 2. Configuring
2.1.
Setting the Coin Counts
(Document BICEXC01)
Figure 9: Example Coin Count Settings
Figure 10: Processor Board as Viewed in
Machine
Table 3: DIP Switch Settings for Coin
Counts
Chapter 3. Operating
3.1.
Control Panel
(Document BICEXO01)
Figure 11: C_E Control Panel (Typical)
3.1.1.
Control Functions During Normal Operation
3.1.2.
Control Functions in
Attendant
Mode
3.2.
Determining Load Size
(Document BIWUUO01)
3.3.
Using the Machine
(Document BICEXO02)
3.3.1.
Normal Operation (Coins Required)
Supplement 2: The Three-Compartment
Supply Injector (Optional)
3.3.2.
Attendant Operation (Attendant Key Required)
3.3.3.
Viewing and Clearing the Accumulator
3.3.3.1.
Viewing the Accumulator
Figure 12: Wash Cycle Accumulator
3.3.3.2.
Clearing the Accumulator
