Milltronics SL10 Series, Инструкция по эксплуатации

Страница: 10 / 93

•
Do not operate the machine while wearing loose or baggy clothes.
•
Always completely fasten buttons and hooks on the arms of clothing to avoid
danger of entanglement in machine mechanisms.
•
Do not operate the machine under the influence of drugs or alcohol.
•
If wearing gloves to load or unload parts, be sure the machine is in
emergency stop mode.
2. WARNING
•
Close all doors and covers of the CNC unit, operation panel and electrical
panel to prevent damage from water, chips, and oil.
•
Emergency stop the machine and turn off the main power during electrical
storms.
•
Check all safety covers regularly to make sure they are properly fitted and not
damaged.
•
Always obtain assistance when handling loads beyond your ability.
•
Do not adjust coolant nozzles while the machine is in operation.
•
Do not remove or interfere with any machine safety devices.
•
Do not wipe the work piece with a rag while the spindle is rotating or the
machine is in motion.
•
Always stop the machine before removing or inspecting a tool.
•
Tools and tooling can be very sharp. Take care when handling.
•
Never place an object or your hand in the carousel or tool changer without
putting the machine in emergency stop.
•
Never place anything between the machine spindle and tool changer.
•
Never use additional clip-on or poorly secured lighting.
3. CAUTION
•
Do not allow chips to accumulate during heavy cutting.
•
Never use compressed air to clean the machine bed.
•
Never wear gloves while operating panel switches.
4