Miller XMT 350, Руководство пользователя

Страница: 31 / 56

OM-278618 Page 27
6-2. Mode Switch Settings
Switch Position
Process Output Control Panel Adjust
Remote 14
Adjust
ArcReach Adjust
WIRE − Gas
GMAW
FCAW
Remote 14 Volts Volts − −
WIRE − Gas (1)
GMAW
FCAW
Electrode Hot Volts Volts Volts
WIRE - No Gas (1) FCAW-S Electrode Hot Volts Volts Volts
STICK EXX18 (1) SMAW Electrode Hot Amps % Panel Amps* Amps
STICK EXX10 (1) SMAW Electrode Hot Amps % Panel Amps* Amps
GOUGE (1) CAC-A Electrode Hot Amps % Panel Amps* Amps
Lift-Arc TIG (1) GTAW Electrode Hot Amps % Panel Amps Amps
TIG GTAW Remote 14 Amps % Panel Amps − −
(1) An ArcReach device will override any control connected to remote 14-pin receptacle.
*See Section 9-5 Alternate Configuration Functions
6-3. Associating ArcReach Device To ArcReach Power Source
Quick Setup Guide:
1 Make connections between power source and ArcReach device. (See section pertaining to mode being used for typical connection
diagrams).
2 This power source has the ability to associate with an ArcReach device at power up, or when an ArcReach wire feeder is triggered. The
Mode Switch on this power source must be set to an “OUTPUT ON” mode to associate with another ArcReach device.
3 See instructions in the owner’s manual for the specific ArcReach device to associate the device to this power source.
4 During the association process the Remote in Use indicator will blink.
5 When the association process is complete, the Remote In Use indicator will be lit. Dependent on the capabilities of the ArcReach device; the
mode switch, voltage/amperage adjustment, and Arc Control adjustment may be overridden by the ArcReach device.
6-4. Powering An ArcReach Smart Feeder In Lift-Arc TIG Mode
To power an ArcReach Smart Feeder in Lift-Arc TIG mode, the OCV will need to be changed to 28.0.
Procedure:
1 Turn mode switch to Lift-Arc TIG.
2 Hold Arc Control button in for 3 seconds until OCV 14.0 or OCV 28.0 is displayed.
3 Turn adjust knob to select OCV 28.0 for powering ArcReach Smart Feeder.
4 Once selected, OCV 28.0 will be the new default.
5 For normal Lift-Arc TIG operation follow the same procedure to select OCV 14.0.