Miller XMT 350, Руководство пользователя

Страница: 35 / 56

OM-278618 Page 31
7-4. TIG Welding Mode - GTAW - Remote ON/OFF
!
Weld terminals are energized
through the remote control in TIG
welding mode.
1 Mode Switch
2 Left Display
3 Right Display
4 Amps Indicator
5 Adjust Control
6 Remote 14 Receptacle
7 Remote In Use Indicator
Setup
For typical system connections refer to
Section 7-1.
Set Mode Switch to GTAW TIG position.
The preset amperage is shown in the Right
Display with the Amps Indicator lit.
Operation
The Adjust Control is used to set desired
preset amperage.
A remote control is required to turn on the
weld output.
If a remote control is connected to the
Remote14 Receptacle and used for
amperage adjustment, the adjustment
will function as a percentage of the pre-
set amperage. The Remote In Use indi-
cator will be lit.
An ArcReach remote control is not
compatible in this mode.
For best results, gently scratch the
tungsten electrode to the work to initi-
ate an arc. To minimize arc flare at the
end of the weld, pull back the electrode
quickly to extinguish the arc.
2 3
1
4
7
6
5
85
278547-A