Miller OM-246 022B, Руководство пользователя

Страница: 12 / 26

OM-246 022 Page 10
3-5.Introduction
A wireless system consists of a transmitter and a re-
ceiver.
1
Foot Pedal Transmitter
2 Hand Control Transmitter
3 Receiver
The foot pedal, hand control, and receiver are cap-
able of remotely turning on the output contactor and
adjusting the output level of a welding power source.
The hand control is equipped with a digital display
capable of providing three parameters: percentage
of available output (default), amperage, and voltage.
Amperage and voltage can only be displayed if weld-
ing power source has amperage and voltage feed-
back available at the Remote 14 receptacle, and is
only viewable while welding, or when feedback is
present. The display is for reference only.

Each foot pedal transmitter and hand control
transmitter has a unique address

The receiver stores the address in permanent
memory

The receiver can only receive information from a
single transmitter

A transmitter can only communicate with a single
receiver.

The receiver can learn a new foot pedal or hand
control address (see sections 3-12 or 3-13 in this
manual for programming instructions).
.
Programming is only required for devices pur-
chased separately. The transmitter and receiver
are programmed when purchased as a system/
pair.
1
2
3
3-6.Battery Installation
1 Battery Case
2 Batteries
Be sure the three AA batteries are
installed into the battery case as
shown.
.
Any type of AA battery, includ-
ing re-chargeable batteries,
may be used (battery life may
vary).
3 Hand Control
Install battery case into remote
hand control as shown.
4
Foot Control
5 Battery Retaining Clip
Install battery case into remote foot
as shown.
Push clip to the side to remove bat-
tery case.
1
2
1
1
805 481-B
3
4
5