Miller OM-246 022B, Руководство пользователя

Страница: 17 / 26

OM-246 022 Page 15
3-12.Programming A Foot Control
! Unexpected weld output can
cause electrical shock. Wireless
remote control can turn weld out-
put on from distant locations. Dis-
connect receiver from remote 14
receptacle and remove battery
from remote control before servi-
cing equipment.
! Turn off welding power source
where wireless remote control
was installed before linking wire-
less remote control to another
unit. During the programming
process, weld output may be
present on machine previously
linked to wireless remote control.
.
Foot control and receiver are pro-
grammed when purchased as a pair.
Programming is only required for
devices that have not been pro-
grammed (paired). Once the devices
have been paired, the address is
saved and can only be changed if the
programming procedure is conduc-
ted with a new device. Only one con-
trol can operate a receiver
1 Receiver
2 LED
3 Learn Button
.
Be sure receiver has been correctly
connected to the power source Re-
mote 14 receptacle (see Section
3-7), before proceeding with pro-
gramming procedure.
.
Foot control must be within one foot
of receiver for successful program-
ming to occur.
4 Foot Control
Verify LED is lit.

Press and hold the learn button (LED
will blink slowly).

While holding learn button, quickly and
firmly depress the foot control.
Upon successful programming, the LED
blinks rapidly.
4
1
2
3
Ref. 803 900 / 805 486