EMF DATA SHEET FOR ARC WELDING POWER SOURCE
Product/Apparatus Identification
Product Stock
Number
MigMatic S500i
059015056
MigMatic S400iP
059015055
Migmatic S400i
059015054
Compliance Information Summary
Applicable regulation
Directive 2014/35/EU
Reference limits
Directive 2013/35/EU, Recommendation 1999/519/EC
Applicable standards
IEC 62822
−
1:2016, IEC 62822
−
2:2016
Intended use
☐
for occupational use
☐
for use by laymen
Non
−
thermal effects need to be considered for workplace assessment
☒
YES
☐
NO
Thermal effects need to be considered for workplace assessment
☐
YES
☒
NO
☒
Data is based on maximum power source capability (valid unless firmware/hardware is changed)
☐
Data is based on worst case setting/program (only valid until setting options/welding programs are changed)
☐
Data is based on multiple settings/programs (only valid until setting options/welding programs are changed)
Occupational exposure is below the Exposure Limit Values (ELVs)
☒
YES
☐
NO
for health effects at the standardized configurations
(if NO, specific required minimum distances apply)
Occupational exposure is below the Exposure Limit Values (ELVs)
☐
n.a
☒
YES
☐
NO
for sensory effects at the standardized configurations
(if applicable and NO, specific measures are needed)
Occupational exposure is below the Action Levels (ALs) at the
☐
n.a
☒
YES
☐
NO
standardized configurations
(if applicable and NO, specific signage is needed)
EMF Data for Non-thermal Effects
Exposure Indices (EIs) and distances to welding circuit (for each operation mode, as applicable)
Head
Trunk
Limb (hand)
Limb (thigh)
Sensory
Effects
Health
Effects
Standardized distance
10 cm
10 cm
10 cm
3 cm
3 cm
ELV EI @ standardized distance
0.08
0.06
0.09
0.05
0.11
Required minimum distance
1 cm
1 cm
1 cm
1 cm
1 cm
Distance where all occupational ELV Exposure Indices fall below 0.20 (20%)
2 cm
Distance where all general public ELV Exposure Indices fall below 1.00 (100%)
82 cm
Tested by:
Joe Krueger
Date tested:
2019
−
12
−
06
XXXXXX‐A
Содержание MigMatic S400i
