Miller ArcStation, Руководство пользователя

Страница: 21 / 44

OM-244 997 Page 17
I. Installing Tool Chest To Welding Table
Use four bolts AA and four locknuts
ZZ for dust tray rails or just four
bolts AA for tool chest brackets and
install tool chest assembly to the
welding table. Be sure that dust tray
rails or tool chest brackets are on
the inside of the end subframes.
If the welding table has an X-pattern
top, do not install dust tray at this
time.
Proceed to Subsection J.
Tools Needed:
1/2 in.
hex bit 3/16 in.
AA and ZZ for dust tray rails or
Side View
just AA for tool chest brackets
AA and ZZ for dust tray rails or
just AA for tool chest brackets
J. Installing Bottom Tray
!
Use two people to rotate
welding table
It is recommended that a piece of
cardboard be placed on the floor to
prevent damaging the finish on the
end subframes. Rotate the welding
table on its side as shown.
Use four bolts AA and four locknuts
ZZ and install bottom tray to bottom
brackets of end subframes.
Tighten all bolts and locknuts.
If the welding table has an X-pattern
top, do not install dust tray at this
time.
Tools Needed:
1/2 in.
hex bit 3/16 in.
AA and ZZ
AA and ZZ
Welding table is shown
with optional tool chest.