Miller Electric MOG-200C, Руководство пользователя

Страница: 15 / 24

OM-805 Page 9
5-2. Overload Protection
READ SAFETY BLOCKS at start of
Section 5 before proceeding.
WARNING
Fuse link F1 protects the grid from
overload damage. If weld output
stops, check fuse link as follows:
Turn Off welding power source and
disconnect input power.
1 Fuse Link F1 (See Parts List
For Rating)
Check and replace fuse link, if
necessary.
Close rear access door.
1
Ref. ST-080 152-C
7/16 in
Tools Needed:
Figure 5-2. Fuse Link Location
5-3. Troubleshooting
WARNING
ELECTRIC SHOCK can kill.
•
Do not touch live electrical parts.
•
Turn Off welding power source, and disconnect
input power before inspecting, maintaining, or
servicing.
HOT PARTS can cause severe burns.
•
Allow cooling period before servicing.
Troubleshooting to be performed only by qualified
persons.
swarn9.1 2/93
Table 5-1. Welding Trouble
Trouble Remedy Section
No weld output. Check and replace open fuse link, if necessary. 5-2
Check electrical input and output connections. 3-3
Erratic or improper weld output. Select correct size weld cables according to Table 3-1. – –
Clean and tighten weld cable connections. 3-3