Miller Electric ICE-60T Torch, Руководство пользователя

Страница: 29 / 44

.
A complete Parts List is available at www.MillerWelds.com
OM-234 163 Page 25
Ref. 803 640-A / 801 400-B
5-6. Sequence Of Piercing Operation
Maintain approximately 90
°
torch
position to surface, and continue
cutting.
Release trigger. Postflow continues after
releasing trigger; arc can be instantly
restarted during postflow by raising trigger
lock and pressing trigger.
!
The pilot arc starts immediately
when trigger is pressed.
Hold torch at an angle to the workpiece.
Raise trigger lock and press trigger. Pilot
arc starts and will go out after 3 seconds
if cutting arc is not established.
Connect work clamp to a clean,
paint-free location on workpiece, as
close to cutting area as possible.
90
°
90
°
Rotate torch to upright position
approximately 90
°
to surface.
When arc has pierced through
workpiece, start cutting.
.
Unit automatically regulates pressure
to 70 psi (483 kPa) for cutting.
CUT GOUGE
.
Recommended maximum piercing capacity
is 7/16 in. (11 mm).
.
Connect work clamp to portion of
workpiece that does not fall away after
being cut.