Miller Electric ICE-100T, Руководство пользователя

Страница: 34 / 56

.
A complete Parts List is available at www.MillerWelds.com
OM-201 872 Page 30
6-10. Cut Charts
100 Amp Machine Torch Shielded Consumables
The following cut charts are based on a distance of 1/8 in (3.2 mm) between torch and workpiece for all cuts.
219 684 219 687 219 677 219 678 219 679
Swirl Ring Electrode Tip Retaining Cap Shield
ICE-100TM Torch
Sense Tab*
226 763
*Shield sense tab 226 763 provides feedback to a compatible torch height controller before starting the cutting process.
.
Shield sense tab is located in the consumable storage box on left side of unit wrapper.
Mild Steel
Arc Current Arc Voltage
Pierce
Delay
Material Thickness Maximum Cut Speeds Optimum Cut Speeds
Arc Current Arc Voltage
Pierce
Delay
Inches mm IPM mm/min IPM mm/min
152 0.5 1/4 6.4 208 5,283 135 3,429
154 0.5 3/8 9.5 119 3,022 77 1,955
157 1.0 1/2 12.7 88 2,235 57 1,447
100
159 1.0 5/8 15.9 61 1,549 40 1,016
100
162 1.5 3/4 19.0 47 1,193 26 660
164 2.0 1 25.4 28 711 18 457
166 2.5 1-1/4 31.8 19 482 12 305
Stainless
Arc Current Arc Voltage
Pierce
Delay
Material Thickness Maximum Cut Speeds Optimum Cut Speeds
Arc Current Arc Voltage
Pierce
Delay
Inches mm IPM mm/min IPM mm/min
153 0.5 1/4 6.4 231 5,867 150 3,810
157 0.5 3/8 9.5 122 3,099 79 2,006
161 1.0 1/2 12.7 79 2,006 52 1,320
100
162 1.0 5/8 15.9 52 1,320 34 863
100
165 1.5 3/4 19.0 39 990 25 635
166 2.0 1 25.4 23 584 15 381
170 2.5 1-1/4 31.8 14 355 9 228
Aluminum
Arc Current Arc Voltage
Pierce
Delay
Material Thickness Maximum Cut Speeds Optimum Cut Speeds
Arc Current Arc Voltage
Pierce
Delay
Inches mm IPM mm/min IPM mm/min
155 0.5 1/4 6.4 253 6,426 164 4,165
157 0.5 3/8 9.5 142 3,606 92 2,336
100
161 1.0 1/2 12.7 108 2,743 70 1,778
100
162 1.0 5/8 15.9 77 1,955 50 1,270
163 1.5 3/4 19.0 57 1,447 33 838
165 2.0 1 25.4 33 838 21 533
Without concern for cut appearance, the fastest speed for cutting material is the maximum cut speed. For better cut angle, less dross, and cut surface
appearance, use the optimum cut speed. The values in the cut charts are basic starting points and each application may require some adjustment to
achieve the best cut characteristics.