Miller Electric Blue Star 145, Руководство пользователя

Страница: 23 / 56

OM-4417 Page 19
6-2. Description Of Controls (Standard Models) (See Section 6-1)
1 Engine Switch
Use switch to control ignition circuit. Turn
switch to On position when starting engine.
Turn switch to Off position to stop engine. En-
gine cannot be started with switch in the Off
position.
Engine stops if oil level is too low. Engine can-
not be restarted until sufficient oil is added.
2
Low Oil Pressure Light
Light goes on and engine stops if engine oil
level is too low.
Engine cannot be restarted until sufficient oil
is added.
Stop engine and add oil if light goes on
(see Section 5-5).
3 Starter Handle
4 Choke Control
Use control to change engine air/fuel mix.
Move control to far right if starting a cold en-
gine. Move control to far left if starting a warm
engine.
To Start :
Open fuel valve (see Section 5-5).
Turn Engine switch to On.
Set choke.
Pull starter handle. Open choke as en-
gine warms.
If the engine does not start, let engine
come to a complete stop before at-
tempting restart.
To Stop :
Turn Engine switch to Off.
Always close fuel valve after stopping
unit. Moving unit with fuel valve open may
cause carburetor flooding and make
starting difficult.
5 Welding Range Table
Use table to determine correct weld amper-
age based on electrode size, type, and mate-
rial thickness.
6
Weld Output Control
Set control at maximum for full generator
power output at AC receptacles
Use control to select weld amperage. Control
may be adjusted while welding.
To Set Weld Output Control: Use table to
determine correct size electrode for weld am-
perage. Select electrode type and set control
to corresponding amperage range on name-
plate. Adjust control to obtain desired weld
performance.
EXAMPLE:
Electrode Diameter: 1/8
Electrode Type: E-6013
Current Control Setting: 90
− 120 A
Notes
Work like a Pro!
Pros weld and cut
safely. Read the
safety rules at
the beginning
of this manual.