Millcreek 4300 TURF TIGER, Руководство оператора

Страница: 13 / 54

Operator's Manual: Millcreek Model 4300 TURF TIGER
®
Spreader
2-1
SECTION 2: ATTACHING THE SPREADER
TO THE TRACTOR
Figure 2A - Specifications for Connecting the Spreader to the Tractor Drawbar
WARNING: For safe operation of the TURF TIGER Spreader, connect the spreader directly to the
tractor drawbar; DO NOT connect the spreader to a three-point hitch.
The TURF TIGER spreader hitch is designed to work with a standardized tractor drawbar. To connect the
spreader hitch to the tractor drawbar, refer to Figure 2A and adhere to the following guidelines:
• Extend or shorten the tractor drawbar to obtain the horizontal distance from the end of the
tractor power take-off (PTO) shaft to the center of the hitch pin hole (as shown in Figure 2A).
• Locate the jack, which is stored under the front of the spreader box. Use the jack to adjust
the height of the spreader hitch so it matches the height of the tractor drawbar.
• Back the tractor into the hitch until the holes line up.
• Fasten the spreader hitch to the drawbar with a hitch pin that fits securely (i.e. so that it will
not come out during spreader operation).
• Remove the weight from the jack by lowering the spreader hitch on the drawbar.
• Return the jack to its storage bracket underneath the front of the spreader box.
ATTENTION: DO NOT store the jack by swinging it alongside the hitch; doing so allows
the handle to hang down and drag on the ground, which may hinder safe and proper
operation.
WARNING: Damage to the spreader or other vehicle, as well as injury to the operator,
may occur if a properly-sized (1" diameter) hitch pin is not installed as recommended. Secure
the hitch pin with the clip as shown.
Connecting the Spreader Hitch to the Tractor Drawbar
ATTENTION: An improperly
located hitch point may cause
damage to the universal joints of
the PTO. The recommended
length of the PTO shaft should
range from 35.83 to 51.42 inches
center to center of the "U" joints.