Millcreek 4300 TURF TIGER, Руководство оператора

Страница: 20 / 54

Operator's Manual: Millcreek Model 4300 TURF TIGER
®
Spreader
3-6
I-86174-A
1
2
3
4
5
6
7
SPINNER
DECK
Figure 3B - Adjusting the Dual Spinner Positioning
Adjusting the Dual Spinner Attachment
The Dual Spinner Attachment provides wide
spreading patterns from 25 to 30 feet with light
application depth (less than 1/8-inch).
Spinner adjustment is critical to producing the desired
spreading pattern results.
From the factory, the
spinner attachment "deck" is installed in the
second and fifth holes from the rear; this
position provides the most uniform 30-foot
wide spreading pattern.
If you need to make
adjustments to this positioning, adhere to the
following guidelines (see Figure 3B):
• Moving the "deck" forward to the
third and sixth holes will result in
more of the material being directed to
the outside of the spreading pattern.
• Moving the "deck" backward to the
first and fourth holes will result in
more of the material being directed to
the center of the spreading pattern.
• Tilting the "deck" will direct the material upwards. (This is accomplished by loosening the front bolts
and rotating the "deck" around the rear bolts.)
NOTE: Tilting the "deck" upwards is recommended for light, wide spreading applications with the
spinners at maximum RPM.
• Tilting the "deck" horizontally may be helpful for heavier applications.
Adjusting the Brush Attachment
The Brush Attachment, with a 10-inch diameter brush, is designed specifically for narrow width applications of
4 feet.
The attachment should be mounted so that the bristles lightly brush against the apron belt. If
the brush becomes worn from extended use, it can be adjusted vertically and horizontally to make up for the
diminished length of the bristles.
ATTENTION: If the brush attachment bristles are rubbing against the apron belt, they will wear down/
damage the belt. Care should be taken that the brush is adjusted properly so that the bristles just lightly
brush against the apron belt.
Adjusting the Horizontal Conveyor
The Conveyor Attachment consists of a 12-inch wide conveyor belt that strictly discharges material to the left of
the machine. There is no variation in the mounting of the conveyor. The
speed of the conveyor, however, can
be adjusted with the Rear Flow Control Valve. Increasing the setting of this control will result in material being
thrown farther to the left of the machine.