Balancing the Multi-tool on the Shoulder Harness
1. Hang the machine on the harness hook, and see
how it balances.
2. Adjust the shoulder strap (8), the harness attachment
on the engine extension tube and the shaft handle
(7) so the attachment head balances at the
required height.
Starting the product depends on whether the engine is cold or warm.
WARNING: The recoil starter can be damaged by abuse.
- Never pull the starter cord to its full length.
- Always engage the starter before cranking the engine.
- Always rewind the starter cord slowly.
Once the machine has been correctly assembled and setup for operation, start
the engine as follows:
1. Press the fuel primer bulb (6) 8 times or until no air bubbles are flowing
through the primer bulb.
2. Turn the engine switch (9) in the on position
3. Move the carburettor choke lever (2) to the ‘on’ position.
4. Pull the recoil starter handle (4) slowly until it engages, then pull briskly.
Repeat this step until the engine fires and starts running.
5. Once the engine is warmed up after a few seconds, adjust the choke lever (2)
back to the ‘off’ position.
6. To control the engine speed, hold down the safety catch (10) on the shaft
handle (11) and pull the throttle trigger (12).
When re-starting a warm engine (that has already been running), choke
activation is not required.
Starting the product depends on whether the engine is cold or warm.
WARNING: The recoil starter can be damaged by abuse.
- Never pull the starter cord to its full length.
- Always engage the starter before cranking the engine.
- Always rewind the starter cord slowly.
Starting the multi-tool
