Assembly
• Do not raise the cutting attachment above waist level during operation,
because that would increase the risk of thrown objects striking your face.
• Avoid steep slopes that would require holding the cutting attachment above
waist level. Avoid slippery slopes that might cause you to lose your balance.
Main Engine/ Shaft Assembly
1. Fit the shoulder strap (8) to the main shaft (1).
2. Attach the main shaft handle (7) to the shaft (1)
by removing the attaching the clamp around the
shaft and tightening the bolts.
Line Trimmer/ Brush Cutter Attachment Assembly
1. Assemble the safety guard (8) to the lint trimmer/ brush cutter attachment.
2. Release the nut. Line up
the two holes of flange and
shield. Use screwdriver to
hold the flange and turn the
socket wrench clockwise (G).
The nut will be released
Fitting the Nylon Cutting Head
1. To fit the nylon cutting head, remove the shield after releasing the nut. Still
holding the flange, place the nylon cutting head on the shaft and rotate
counterclockwise (H). The nylon cutting head is
now fitted.
2. To remove the nylon cutting head, use screwdriver
to hold flange and rotate clockwise.
Fitting the Blade
1. To fit the blade, take the outer flange off after releasing the main nut, then
put the blade, outer flange shield and nut according to priority (1). Note the
blade rotation direction (J). Use screwdriver to hold flange and tighten nut
counter- clockwise. Ensure the nut is well tightened.
2. To release the blade, use
screwdriver to hold flange
and release nut, the blade
than then be removed.
WARNING: Please make
sure the cutting head has
been assembled correctly before use.
