Milky 13312, Руководство по эксплуатации

Страница: 14 / 28

14
ERRORS
1. On display is shown Er2 or Er3 and pasteuriser does not work – Pull out the plug and
call the authorised service - do not repair it yourself!
2. If there is no sign on display, then the temperature safety sensor disconnected whole
device. When temperature cools down, display shows ˝---˝. Fill the pasteurizer with
water using the already fixed inlet hose until the water is coming out of the outlet
hose.
3. If there is no sign on display and temperature cooled down and display is still black,
then safety thermocouple disconnected whole device.
Pull out the plug and call the
authorised service - do not repair it yourself!
SAFETY AGAINST OVERHEATING
In case that in secondary coat is not enough water or that temperature of secondary
water rises over 100 °C the security switch switches off all functions on the device. In this
case you have to check which step from manual use was not done properly. The mistake
has to be removed – usually is not enough secondary water in pasteurizer. Fill the pas-
teurizer with water using the already fixed inlet hose until the water is coming out of the
outlet hose.
CLEANING
Discard any remaining water and cool down the device before cleaning. The milk con-
tainer and the cover should be cleaned with hot water adding fat soluble detergents.
Afterwards these parts will be rinsed with pure water. The pasteurizer shall be cleaned
only with wet duster and afterwards dried with dry duster. Do not use abrasive materials
to avoid scratches.
BEFORE CLEANING MAKE SURE THAT THE PASTEURIZER IS SWITCHED OF, DI-
SCONNECTED FROM THE MAIN SUPPLY AND COOLED DOWN (CONTAINER AND
MEDIUM)!
UNDER NO CONDITION THE PASTEURIZER SHOULD BE SUBMERGED IN WATER