Receiver
GV34 Valve
Push-on
Connector
Remote Control Preparation
1. Connect the wiring harness to the receiver box,
by pushing the wire connector on to the receiver
circuit board. The plug will only go on one way so
please ensure that the wires are pointing up and the
slot in the board is in line with the tab on the wiring
harness plug.
2. Connect the wires as shown. Please note that
the “L” connectors are different sizes; the smaller
one
fi
ts to the lower connection and the larger one
the top connection on the top left hand side of the
valve. The other two wire connectors can be
fi
tted to
either terminal located to the left of the
fl
ame control
button.
3. Remove the remote control receiver lid.
4. Fit four AA 1.5 V alkaline batteries. Re
fi
t the lid.
5. Place the remote control receiver on the base of the
fi
replace beside the valve.
6. Fit the 9 V alkaline battery to the handset
transmitter.
Remote control operating instructions are on
pages 24–25 of this manual and are supplied with
the remote control kit.
CAUTION
DO NOT PUT BATTERIES IN THE REMOTE
CONTROL RECEIVER until the wires are
connected to the burner control unit as short-
circuit could result in the destruction of the
electrical components.
CAUTION
DO NOT USE
a screwdriver or other metallic object
to remove the batteries from the receiver or the
handset! This could cause a short circuit to the
receiver.
Remote control
receiver
GV34 Valve
Receiver
Push-on Connector
16
INSTALLATION