2121 Blount Road, Pompano Beach, FL 33069 MileMarker.com 1.800.886.8647
PAGE 4
Before wiring, match the color of the motor terminals and power cable
Connect the three short cables (red, black, yellow) to the color-coded terminals on the motor
Connect the red long cable from the solenoid to the POSITIVE battery terminal and the long black cable to the NEGATIVE battery terminal
Connect the other end of both to the motor
Connect thin black wire (ground wire) from the solenoid assembly to the motor
Remove socket cover on the solenoid and inset the plug of the remote control
NOTE: After the winch is mounted and powered, check the direction of the power in and power out buttons on the remote. If you
wish to switch the direction, disconnect the cable from the battery, switch the yellow cable with the blue, and reconnect the
battery cables.
Disconnect the remote when not in use
Fig. 3
Socket cover
Solenoid assembly
Yellow
Blue
Yellow
Red
Red
Black
Black
ground wire
Battery
Motor
Engaged position
Disengaged position
Clutch handle
Clutch handle
Fig. 4
Blue
Battery/red
6.
7.
8.
9.
10.
11.
Engage and disengage the clutch by turning the clutch handle (Fig. 4)
Pull the cable through the fairlead and connect the hook
NOTE: The use of at least a 650 CCA battery is recommended
12.
13.
