Milazo Adult Bicycles, Инструкция по эксплуатации

Страница: 79 / 98

77 InstructIon Manual
Never ride with loose pedals.
- Check that pedal bearings are properly adjusted. Move the
pedals up and down, and right to left, and also rotate them by hand. If you detect any looseness or
roughness in the
pedal bearings then adjustment, lubrication or replacement will be required.
- Ensure front and rear pedal reflectors are clean and securely fitted.
- Ensure toe clips, if fitted, are securely tightened to the pedals.
Lubrication and Adjustment
Many pedals cannot be disassembled to allow access to the internal bearings and axle. However,
it is usually possible to inject a little oil onto the inside bearings, and this should be done every six
months. If the pedal is the type that can be fully disassembled, then the bearings should be removed,
cleaned and greased every six to twelve months. Because of the wide variety of pedal types and
their internal complexity, disassembly procedures are beyond the scope of this manual and further
assistance should be sought from a specialist.
Attachment
Note : The right and left pedals of a bicycle each have a different thread and are not interchangeable.
Never force a pedal into the incorrect crank arm.
The right pedal, which attaches to the chainwheel side, is marked ‘R’ on the end of the axle, and
screws in with a clockwise thread. the left pedal, which attaches to the other crank arm, is marked
‘L’ on the axle, and screws in with a counter clockwise thread.
Insert the correct pedal into the crank arm and begin to turn the thread with your fingers only.
Detailed maintenance
Turn counter-clockwise
to tighten.
L = Left
Turn clockwise
to tighten.
R = Right