MiLAN MIL-P3720, Быстрая установка

Страница: 9 / 32

M
M
I
I
L
L
-
-
P
P
3
3
7
7
2
2
0
0
Q
Q
u
u
i
i
c
c
k
k
I
I
n
n
s
s
t
t
a
a
l
l
l
l
G
G
u
u
i
i
d
d
e
e
5
Hardware
Basic Hardware Installation
Installing and Connecting the Printer to the Network
To install the MIL-P3700 series of direct connect print servers and to
print a test page do the following:
1. Record the print server’s twelve-digit hardware address (Ethernet or
MAC address). The number is located on the bottom of the unit (for
example, 00-40-c8-XX-XX-XX where X is a hexadecimal number).
2. Attach the network cable from your hub or network port to the RJ-
45 port (marked as 10/100Mbps). Use Category 5 (UTP) cable.
3. Plug the print server (MIL-P3720) directly into the printer’s parallel
port or into an extender cable.
4. Connect the power cable (5VDC power supply provided) to the
print server.
5. Check to see if the Link (L) LED is on solid, and 30 seconds later
the Net LED is flashing randomly. This indicates activity on the
network.
6. Check to see if the Port (P) LED comes on (within 7 seconds).
7. Wait for 30 seconds (until the Port (P) LED stops flashing).
8. Print a test page by pressing the TST button once with a small
pointed tool.
9. Refer to the relevant chapter in this document for the specific
network operating system and continue installation.
Contact MiLAN Technology’s LAN technical support if you have
problems or questions when installing the print server.