Installation Guide: MIL-110FXC
4
5
S l i d e S w i t ch e s
The MIL-110FXC has slide- type switches, with five
positions as shown in Figure 3. Slide to the right side
for “on” or slide to the left side for “off”. The figure
below shows switches in the “on” position.
Figure 3
S w i t ch B a n k
Use switches 1 and 2 to select a transceiver address-
from 0 through 3. Almost all devices will expect to see
address 0 selected. Use Table 1, “Configuration
Option,” on page 5 for a device which needs to see an
address different from 0.
NOTE: For a single transceiver on the MII, the transceiver should be set to ‘0’ address (default). This causes the transceiver to
power up in an isolate mode until the connecting device enables communication on the network. If this function address does not
enable device, turn switch 1 to “on”.
NOTE: Switches 4 and 5 are not used. Setting either switch in the OFF position will render the unit inoperative(Inop).
I n d i c a t o rs
•
POWER:
When illuminated, power is being
received from the MII port.
•
HDX or FDX:
When illuminated, the MIL-110FXC
is running at full-duplex operation (FDX). When
the LED is off, the device is running at half-duplex
operation(HDX).
Table 1: Configuration Option
SW1
SW2
Function Address
Off
Off
0 (Default)
On
Off
1
Off
On
2
On
On
3
Table 2: Switch 3
SW3
Functions
On
Half-duplex
Off
Full-duplex (Default)
