Installation Guide: MIL-110FXC
6
3
•
Collision:
When illuminated, collision is occur-
ring.
•
Transmit Data:
When Illuminated, data is trans-
mitting.
•
Link:
When illuminated, Link is sensed.
•
Receive Data:
When illuminated, data is being
received.
C a l c u l a t i n g t h e C a bl i n g D i s t a n c e
The cable distance is limited to the attenuation loss
over the cable, at splices, and connections. Power
budget is determined by the launch power number,
-15dBm, minus the receiver sensitivity number,
-31dBm, which is 16dBm. Use the following equation
to determine the correct cabling distance.
CL< 2 x (power budget -3 x the number of splices)
I n s t a l l a t i o n
1. Turn off the host device (optional).
2. Attach a duplex, 9/125
µ
m single-mode fiber cable
to the SC connector on the transceiver.
3. Insert the MII connector into the female 40-pin
connector on the device you wish to connect.
C o n fi g u r a t i o n
C o n n e c t o rs
Figure 1 is an example of the SC-type connector.
Figure 1. SC-type Connector
Figure 2 is an example of a 40-pin MII connector.
Figure 2. 40-pin MII Connector
Rear View
.
