Milagrow AguaBot7.0, Руководство по эксплуатации

Страница: 20 / 22

Installation of the intelligent water tank/
trailing bar/ mop
1. Installation of the trailing bar/ mop:
2. Installation of the intelligent programmable tank:
Install the mop onto the position where it is to be attached.
As shown in Fig. 1, mount the trailing bar onto the unit by aligning it with holes.
As shown in Fig. 2, mount the small dust bin onto the water tank first before use.
As shown in Fig. 3, take out the water tank, open the flexible plastic inlet, inject clean water, and
close the inlet lid.
As shown in Fig. 4, place the water tank into the cleaner, close the cover and the unit is ready to
mop.
Before injecting water into the water tank, take the tank out. Putting
water directly into the installed water tank may cause water to go
into the unit and may lead to short circuit.
When using the water tank, it is prohibited to turn the unit upside
down otherwise the water will get into the Robot & cause damage.
After the water tank is refilled, clean it if there is water around the
water tank.
The cleaner will make a voice prompt “ inject water, please” if
the water tank runs out of water (see page 8 for more).