Five SFP ports.
DC power jack connector.
Reset button
To use the reset button, hold it and then turn on the device, while still holding the button.
Release the button when the green LED starts flashing, to reset the RouterOS configuration.
To load the backup bootloader, you can start holding the button after power is already applied.
Release the button after LED is no longer flashing (~20 seconds) to cause the device to look for Netinstall servers (required for reinstalling
RouterOS over the network). You can also release the button at the time when the device has appeared on the Netinstall utility device list.
Regardless of the above option used, the system will load the backup RouterBOOT loader if the button is pressed before power is applied to the device.
Useful for RouterBOOT debugging and recovery.
Accessories
The package includes the following accessories that come with the device:
Please visit wiki pages for the MikroTik SFP module compatibility table:
https://wiki.mikrotik.com/wiki/MikroTik_SFP_module_compatibility_table
When using devices that come with separated SFP+ cages, it is still not recommended to deploy the S+RJ10 transceivers beside each other. Use S+RJ10
in every second interface to avoid transceivers overheating which may cause unpredictable behavior.
https://wiki.mikrotik.com/wiki/S%2BRJ10_general_guidance
Operating system support
The device supports RouterOS v6. The specific factory-installed version number is indicated in the RouterOS menu /system resource. Other operating
systems have not been tested.
