Federal Communication Commission Interference Statement
FCC ID: TV7RB912G-2HPND / TV7RB912G-5HPND
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of
the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the
user’s authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation. This device and its antenna must not be co-located or operation in conjunction with any other
antenna or transmitter.
IMPORTANT: Exposure to Radio Frequency Radiation.
63 cm minimum distance has to be maintained between the antenna and the occupational user and 140 cm to general public.
Under such configuration, the FCC radiation exposure limits set forth for an population/uncontrolled environment can be
satisfied.
List of additional approved antennas:
Omni Directional (fiberglass pole) WLO-2450-15 15 dBi
Omni Directional (hor. polarization) HP, ODH 24-13 13 dBi
Sector SA 24-90-17-WB 17 dBi
Panel WLP-2450-20 20 dBi
Dish DC 24-HD-PFIP 24 dBi
Antenna Installation. WARNING: It is installer's responsibility to ensure that when using the authorized antennas in the United
States (or where FCC rules apply); only those antennas certified with the product are used. The use of any
antenna other than those certified with the product is expressly forbidden in accordance to FCC rules CFR47 part 15.204. The
installer should configure the output power level of antennas, according to country regulations and per antenna type.
Professional installation
is required of equipment with connectors to ensure compliance with health and safety issues.
8-Jan-15
