MikroKopter OktoXL, Инструкция по эксплуатации

Страница: 12 / 74

need to clean or rinse it immediately with plenty of clean and fresh water. Then a doctor should be consulted.
Charging the LiPo
Only charge a LiPo with an appropriate charger and integrated balancer.
The necessary settings can be found in the manual for the charger.
It is absolutely necessary that the recommendations in the instruction manual be followed.ger. After use the
LiPo should cool down before the next recharge.
The LiPo in the ARF-MikroKopter consists of multiple internal cells. In addition to the cable with the Deans connector
another jack, the balancer, is connected with 5 cables to the LiPo. In that case the individual battery cells are monitored
during charging. With properly set values on the charger, charging the LiPo will be finished at a charge voltage of 4,22V
per cell.
The settings you need to charge a LiPo can be found in the manual of the charger.
Example: Connection to a Robbe POWERPEAK charger:
What does the inscription mean on the LiPo?
Example: 5000 / 14,8V / 4S1P / 20C / 4C Charge
5000 => Capacity of the LiPo (here 5000mAh = 5Ah)
14,8V => Voltage 14,8Volt
4S1P => 4S = 4 cells are connected in series / 1P =
no further cell is connected parallel.
20C => Maximum current of the LiPo. This is
calculated as follows: (Capacity/1000) x
Max. current (5000/1000) x 20 = 100A).
4C Charge => Maximum permissible charging current.
A 5000mAh LiPo can be charged with
max. 20A (4x5000mA).
For a longer life LiPos should be charged only max. 1C.
LiPo storage
For the storage of a LiPo over a longer time period (e.g. over the winter months), he should not be quite fully charged.
Recommend is a single cell voltage of ~ 3.8 V. Fully charged LiPos can otherwise be damaged during long storage. The
LiPo should be checked at longer storage and, if necessary, be refueled.
Using BID (Robbe)
If a Robbe charger is used to charge the LiPos a BID-Chip can be
assigned to each LiPo. This BID chip stores all the relevant data for
charging the battery. When charging a LiPo, the corresponding BID-Chip is
connected to the charger. This gives the battery charger the necessary
battery parameter for specific LiPos.
Page 8 HiSystems GmbH
!
info info