Page 14
8.2. Getting Started
Connect the SpeakUp click board to the computer via the USB
cable. It will be recognized as a USB Human Interface Device (HID)
in the Device Manager of the Control Panel.
After the successful connection, the SpeakUp click
™
board
will perform ambient noise detection and calibrate itself. The
process lasts about 10 seconds. It’s done when the red signal
LED turns off. After that the board is ready for recording voice
commands. You can set custom calibration parameters for
any subsequent usage in the
Project Settings
(see page 18).
Ambient Noise Detection
Once you connect the SpeakUp to your computer you’re just a few
clicks away from configuring it. The set-up process is dead simple.
Launch the application, and it will lead you through the initial
steps of recording and assigning commands.
