Page 20
Page 21
Figure 5-1: Placing
ICD2 connector
The microcontroller can be also programmed with
ICD2
or
ICD3
programmer. These programmer is connected
with mikromedia board via
ICD2
CONNECTOR BOARD
.
Programing with
ICD2 or ICD3 programmer
In order to enable the ICD2 and ICD3 programmers to be connected to the
development system, it is necessary to provide the appropriate connector
such as the
ICD2 CONNECTOR BOARD
. This connector should be first
soldered on the CN5 connector, Figure 4-15. Then you should plug in the
ICD2 or ICD3 programmer into it as shown in figure 4-14.
Figure 4-15:
Connecting ICD2 or ICD3 programmer
Figure 4-14:
Placing ICD2 connector
