MIKOM MR301B Power, Руководство пользователя

Страница: 52 / 81

User’s manual for Repeater MRx01B Power
M0079A1A.doc Id.-No. 151775 Page 52 10-March-00
For the exchange of a conversion module or the installation
of a new conversion module, the slave address of the synthesizer
has to be set. This can be done by means of hex-coded
rotary switches mounted on the lower side of the modules
Hex-coded rotary switch for UL
Hex-coded rotary switch for DL
The synthesizer address must be set like shown
in the following table:
Conversion module
Address
UL DL
Channel one 0 1
Channel two 2 3
Channel three 4 5
Channel four 6 7
figure 8-4 Position of hex-coded
rotary switches
table 8-5 Address of synthesizer
Conversion modules with variable bandwidth have four rotary switches. The synthesizer
address must be set like shown in the following table:
Filter 1 Filter 2
UL DL UL DL
Channl one 0 1 0 1
Channel two 2 3 2 3
Channel three 4 5 4 5
Channel four 6 7 6 7
table 8-6 Adress of synthesizer, conversion modules
with variable bandwidth
figure 8-7 Position of hex-coded rotary switches
at variable bandwidth module
Further instructions for band selective modules with variable bandwith can be found in a
separate document.