Mikasa MRH-600DSA-DX, Инструкция по эксплуатации

Страница: 5 / 28

●
●
DANGER:
3
WARNING:
CAUTION:
4.3 Precautions about where to use the machine
Do not run the engine in an unventilated location, such as indoors or in a
tunnel. The exhaust gas from the engine is carbon monoxide and is deadly.
Do not operate the machine near open fires.
4.4 Precautions when working
Ring stopper
is useless
Steep gradient
Ring stopper
is buried
Roadbed is soft
Danger of
rollover
Stop
Do not raise
handlebar
in work
Muffler
Burn warning
●
●
●
●
●
●
●
●
●
Keep engine speed as specified during the work and traveling.
Especially in inclined area, keep the specified speed. Otherwise,
engine may stop and the roller goes down by its weight.
If it happened, move Travel Lever to “Stop” position(Neutral position)
promptly, which lets the drum not to roll automatically. Then use
Parking Brake to lock drums, and put on the ring stopper for the safety
sake.
If the inclined angle is too big or the roadbed is too soft, the ring
stopper is useless as referred to the right figure.
Select the suitable ring stopper depends on working conditions.
In the work with inclined area, the well-skilled worker is required to
avoid any danger.
Working with side slope may have danger of rollover. Do not use the
machine, which becomes working with side slop, and move the
machine to go vertical up & down against slope with speed at low
possibly by adjusting the speed of Travel Lever.
Besides, keep other workers away from the downwards of the
machine.
Keep other workers away from the roller in operation especially in
case of fears of the machine fell down.
In the work with inclined area, operator should stand at right side or
left side of Handle Bar, and be sure not to go straight back of Handle
Bar.
In the work in reverse, operator also should stand at right side or left
side of Handle Bar, avoiding from standing back of Handle Bar.
Lock parking brake in parking, together with ring stopper in front and
back of drums.
At the slope, avoid parking as much as possible.
But in the case of parking in inclined area, try to lock parking brake at
slow speed in operation to find the locking position safely, then
confirm parking lock safely. Travel Lever returns to Neutral position to
stop, and raise ring stopper at each drum.
Select the suitable ring stopper especially for inclined parking.
Do not tough with muffler when it is hot.
●
●
●
●
●
●
●
●
●
Before starts engine, be sure to keep other people or obstacles away
from the roller. Then move Travel Lever to neutral position keeping
with Vibration Lever off to start engine.
Always confirm the positions of obstacle such like telephone pole or
wall, and keep safely distance from other construction equipment and
workers.
Always keep any other workers out in working range.
Do not operate the machine with handlebar being folded, because it is
not easy to keep the right position and be dangerous. Especially in
reverse motion, the operator may be wedged between the one and
obstacle.
Do not look away, and do not drive aggressively. Switch
Front-Reverse motion with Travel Lever slow and smoothly. Do not
operate at high-speed, sudden acceleration, nor sudden stopping
except emergency.
Keep the 2m distance at minimum from a block wall, and be
sure to turn always in forward traveling at safer area.
In the night, always light up a working place good
enough to illuminate.
When fogging or in a strong wind is expected danger in working
conditions, cancel the work immediately.
If you face any trouble or abnormality of the machine, cancel the work
immediately, and contact business owner to have suitable measures.