Mikado LOGO 10, Руководство пользователя

Страница: 55 / 64

Manual LOGO 10 Page 55 ©Mikado Modellhubschrauber
12mm
Ø 8mm
5mm
45mm
10mm
240mm
15 Canopy
15.1 Trimming and Taping
Tip: When cutting, always leave
generous edges at first. Cut to final
size after you have fitted parts.
On both of the white halves, a mar-
king indicates where the window be-
longs. With a scissors, trim away the
excess material at the two white hal-
ves of the canopy along the
insides of these markings.
Unlike in the picture, please do not
cut sharp edges at the top and back
ends of the canopy. The rounded
edges must be retained for stability.
After taping the two halves together
and fitting the window, you may trim
away any excess edges.
In general, we recommend to use
transparent scotch tape on the insi-
des of the three canopy parts for con-
necting them. Taping provides suf-
ficient stability and the procedure is
easier and less time-consuming than
gluing (for instance). Corrections, if
necessary, are no problem either.
The LOGO 10 canopy is attached
to the main frame in three places. The
lower part of the canopy is placed
between the front landing bow and
the main frame. For this, you need to
make to cut-outs as shown in the pic-
ture. The back part of the canopy is
attached at the canopy bolts of the
main frame using two rubber
grommets.
The final fitting of the canopy must
be tested when the helicopter is fully
equipped (with battery, servos and
linkages). Ensure that the servo
arms and linkages do not have any
contact with the canopy. In the front
area, the battery may and should
have contact with the canopy provi-
ding additional support. When more
than 12 cells are used, extra room in
the nose of the canopy by padding
the battery, thereby lifting it slightly.
When the final position of the ca-
nopy has been determined, mark the
two holes for attaching the canopy at
the bolts, then drill the two holes (Ø 8
mm).
rubber grommets
window
right half of
canopy