4
Wireless Driveway Alarm Instruction Manual • 03.04.12
Testing the System
Placing Receiver and Testing System
Receiver Placement
Installing Transmitter Batteries
• Place the indoor RECEIVER in a convenient location.
• Plug the AC transformer into a 110 VAC outlet and the
charger cable into the receiver.
• The power LED on the front panel will light up, and there
will be a confirmation “beep” tone.
• When a car passes the SENSOR, a signal is transmitted
to the RECEIVER from the TRANSMITTER. After the
RECEIVER receives the signal, it will chime and the visitor
alert LED will turn on and remain lit. The LED can be reset
by pressing the RESET button, but it is not required.
• The LOW BATTERY LED alerts you when the two (2)
“AA” batteries in the outdoor TRANSMITTER need to
be replaced.
• Test the range and system by having someone drive an automobile past the SENSOR to be sure
the RECEIVER is activated when the vehicle has passed the SENSOR. Kitchen appliances or other
electronics may interfere with reception. It may be necessary to adjust the position or relocate the
RECEIVER for optimum results. See Troubleshooting Section on page 6.
• Make sure the SENSOR wire is plugged into the TRANSMITTER.
• Temporarily place TRANSMITTER on the mounting post in ground.
• With TRANSMITTER in desired location install two (2) “AA” batteries.
IMPORTANT: “AA” batteries must be installed at the site where the TRANSMITTER will be located to ensure
proper calibration of the transmitter.
Insert
“AA” Batteries
MIN
MAX
SENSITIVITY
TRANSMIT
TER CODE
TRANSMIT
TING
1 2 3 4
MIN
MAX
SENSITIVITY
TRANSMIT
TER CODE
TRANSMIT
TING
1 2 3 4
RESET BUTTON
LOW BATTERY LED
TRANSFORMER INPUT
VOLUME CONTROL
VISITOR LED
POWER LED
